Pico
™
on-the-go car seat
INSTRUCTION MANUAL
25
24
Connect lower anchor connectors to vehicle lower anchors.
Position red release button of push-on connector facing
away from car seat so that lower anchor belt is not twisted.
Position the slot of the push-on connector onto the lower
anchorage. Push connector in to lock onto the lower
anchorage. You should hear a “click”.
Pull on connector to be sure it is locked onto the anchorage.
Repeat for connector on opposite side.
Place car seat forward-facing in the vehicle
seat location selected with car seat centered
between the vehicle lower anchors.
Remove tether from storage compartment
on back of car seat and place in seating
area of car seat.
Locate the tether anchor for the seating location being used.
NOTE:
Check vehicle owner’s manual for tether anchor locations
and proper routing of tether strap in relation to vehicle
headrest. DO NOT use cargo tie downs or other attachment
points not intended for use with car seats. Look for the
tether anchor symbol:
Attach tether hook to vehicle tether anchor and pull strap to
remove slack from tether. Check that the tether strap is not twisted.
Final tightening will occur in a later step.
NOTE:
To lengthen the tether strap, push the tether adjuster
button and pull the tether strap through the adjuster.
Tighten lower anchor belt to secure the car seat.
Place your hand in center of car seat bottom and use
leverage to compress the car seat into the vehicle cushion
while tightening the lower anchor belt.
NOTE:
Check that both sides of lower anchor belt are tight. It may
be necessary to pull some strap through the seat back frame
or to gently rock the seat back left to right while tightening.
Snugly adjust tether strap by pulling on free end.
NOTE:
Check that both sides of the tether strap are tight.
It may be necessary to pull some strap through
the tether hook toward the adjuster.
1
2
1
2
Tether MUST always be used when available.
