4 of 14
WX-501-0537 • 01.22
Operating Modes
The Click 512 has three operating modes:
Run
,
Device Setup
, and
Serial Convert
. These modes are accessed through
the mode menu, which is controlled via the push-button; the system (multicolored) LEDs light up to show which mode
you’re currently on. The table below shows the LED color and state associated with each operating mode or task.
Operating Mode/Task
Selection LED State
Operating LED State
Run
Blue solid
Blue solid
Device Setup
Green solid
Green solid
Serial Convert
Yellow solid
Yellow solid
Reset
Red solid
–
The LED state during the mode selection process can be either flashing or solid. If the current mode is a flashing
mode, the corresponding LED will flash during mode selection. However, after a flashing mode is selected, the
selected mode LED will not flash—the red LED will flash instead.
Navigating the Menu via the Push-Button
The menu is navigated via the push-button using hold and press actions:
■
Hold –
Pressing and then holding for at least 1½ seconds allows you to enter the Click 512 mode selection process.
■
Press –
Pressing and then quickly releasing the push-button allows you to make a selection in the menu.
The menu is used to select and run an application’s operating modes. Select a mode by navigating through the
main menu (multicolored LEDs) and the submenus (yellow and red LEDs) as described below:
1. Enter the main menu by holding the push-button down. Continue holding the push-button to cycle through the
entire menu.
2. Release the push-button once the cycle reaches the desired mode (see Table 9.1).
3. Press the push-button again to select the mode. Once the mode is selected it will start running. If you selected
to reset the device, the submenu of yellow LEDs will start (the first LED will light up).
4. Hold the push-button to cycle through the options of the submenu.
5. Release the push-button once the desired option is displayed.
6. Press the push-button again to select the option. The mode will now start running.
Run Mode (blue solid)
Run mode is the first mode presented in the mode selection process. Once you have configured the device using
Click Supervisor (see the Device Setup Mode section below), use the push-button to select Run mode (blue solid).
Note.
The SmartSensor HD should be configured beforehand, using SmartSensor Manager HD (SSMHD), to push
event data (see the image below and the
SmartSensor HD User Guide
for more information).
