10 of 14
WX-501-0537 • 01.22
After being reset, the Click 512 will return to the last mode that it was in.
Computer Configuration
The Click 512 must be configured using the Click Supervisor software. See the knowledge base article
0514
Installing and Using Click Supervisor
for instructions on how to download and install Click Supervisor and how to
connect to your device using the software.
The Click 512 can be configured using the Expert driver (see the figure below).
After you have made configuration changes on a driver and saved it to the Click device, the word “current” will
appear after that driver to indicate the driver that is currently loaded onto the device.
Note.
Changing any of the settings on any driver and saving them to the Click device will change those settings
on all drivers.
The Backups option can be used to read configurations that have previously been saved to file.
Expert
The Expert driver allows you to configure the Click 512. The driver is divided into two tabs,
System
and
512
.
The System tab is divided into three subtabs:
General
,
Comm
, and
Autobaud
.
The
General
subtab contains information about the device (see the figure and table below).
