* Your actual battery life may vary depending on system alerts, notifications and environmental factors.
WAVE w10 MANAGEMENT APP
The WAVE w10 Management App is a simple to us app that enables you to monitor
the status of the Hub, wearables and other accessories. The app may be used on
smartphones and tablets (recommended).
Note: Although recommended, it is not necessary to have the WAVE app open or
active while using your w10. The system will monitor your swimmers and non-
swimmers using the most recent settings.
SETTING UP THE APP
1.
Power on the w10 and allow the Hub to fully complete the Start Up Process.
2.
Open your device’s settings and go to the WiFi settings page.
3.
Look for the WAVE wireless hotspot w10-ap-1539d6 to appear.
4.
Select and join the WAVE wireless network using the password “WaveNetwork”.
5.
Open your device’s web browser program (Chrome, Safari, etc.).
6.
Enter the following URL in the address bar: http://start.wavew10.com:3001 or http://
192.168.8.1:3001, if the first does not work.
You should be automatically redirected to the WAVE management page, but if that
does not happen after a few minutes, please restart the Hub.
To do so, press the power
button for 5 seconds and release it.
Wait 30 seconds, then turn the Hub on again by
pressing the power button again.
Once the Hub is up and running, open your device’s
browser and go to http://w101539d6.hub.wavedds.net to access the WAVE system
page directly. If it does not appear after a few seconds, reload/refresh the page.
Note: Your device must have WiFi activated and be on the WAVE wireless network to
WAVE w10 Swimmer Safety System User Guide v0721-1
Page of
9
27
