Wave Wireless Networking SC5800, Руководство пользователя, Страница: 90 / 108

SC5800 User Manual
88
Object ID Group Object Type Access Description
degradation can be expected
when operating using channel
plan D mode and the chosen
frequencies are close to the
sub-band edges i.e. a choice of
one of the high frequencies in
the lower sub-band and one of
the lower frequencies in the
upper sub-band. The allocation
of Channel plan D frequencies
is Lower Sub-band - 5735-5771
MHz, Upper Sub-band - 5804-
5840 MHz. The user must take
note of whether the radio is a
high or low band unit before
choosing a set of transmit and
receive frequencies. Note also
that THE TX AND RX
FREQUENCIES MUST BE
SELECTED BEFORE BAND
PLAN D OPTION IS SELECTED
VIA THE MIB.
1.3.6.1.4.1.1316.1.1.1.2.2.4 mdrmteRxFrequencyPlanD INTEGER read-write Refer to the
mdrmteTxFrequencyPlanD
description.
1.3.6.1.4.1.1316.1.1.1.2.2.5 mdrmteTransmitBand INTEGER read-only This value is read from the
Outdoor Unit via the Indoor Unit
and defines whether it transmits
in the Lower Sub-band - 5735-
5771 MHz or Upper Sub-band -
5804-5840 MHz.
1.3.6.1.4.1.1316.1.1.1.2.2.6 MdrmteReserved2 INTEGER
1.3.6.1.4.1.1316.1.1.1.2.2.7 mdrmteRegulations INTEGER This parameter is read from the
Outdoor Unit via the Indoor Unit
and defines regulatory
compliance of the Outdoor Unit.
1.3.6.1.4.1.1316.1.1.1.2.2.8 mdrmteAutoRecovery INTEGER read-only This feature is used if the user
is installing a link from one side
and there is no assistance on
the opposite side of the link. It
mitigates against the link failing
and not being able to be re-
established. If “auto recovery”
is enabled, the required
operational RF parameters are
programmed into the Outdoor
Units by the local and remote
Indoor Units. If communication
between the two Indoor Units
has not reactivated within 5
seconds, the previous (working)
'default' RF parameters are
programmed into the respective
Outdoor Units.
1.3.6.1.4.1.1316.1.1.1.2.2.9 mdrmteOURateOverride INTEGER read-write Deprecated
1.3.6.1.4.1.1316.1.1.1.2.2.10 mdrmteOUDataRate INTEGER read-write A settable rate that allows a
reduced transfer data rate over
the RF Link.
1.3.6.1.4.1.1316.1.1.1.2.2.11 mdrmteTxFrequencyCurrent INTEGER read-only This value [MHz] is read back
from the Outdoor Unit and
defines the transmit frequency
of the Outdoor Unit.
1.3.6.1.4.1.1316.1.1.1.2.2.12 mdrmteRxFrequencyCurrent INTEGER read-only This value [MHz] is read back
from the Outdoor Unit and