Wave Wireless Networking SC5800, Руководство пользователя, Страница: 37 / 108

SPEEDCOM SC5800 User Manual
35
5.4 Software Setup
Refer to Section 6, NMS Software, page 39, for setting up the following:
•
Payload interface.
•
Service Channel (Wayside) serial port.
•
Auxiliary in/out port.
•
General link parameters.
5.5 Functional Test
After completing the physical installation of the Indoor Units, antennas, Outdoor
Units and the interconnection cables, you need to commission the system. This
procedure describes how to set up the minimum requirements for successful
SC5800 system operation.
5.5.1 Link Bit Error Rate Performance Test
To start: when the link is setup correctly, the RF Link LEDs on both IUs on both
sides of the RF link should be GREEN.
When the link has been setup and is running error-free:
1. Clear the Indoor Unit Log using Reset Button Position ‘2’
2. Clear the Indoor Unit Errors using Reset Button Position ‘1’
Perform a link bit error rate performance test as follows:
•
Connect a bit error rate tester to the payload interface of the link.
•
Run data over the link for a period of 24 hours.
•
Record the BER.
•
Record the LED statuses.
Check the Indoor Unit Packet Error Results via the NMS or via SNMP access to the
Indoor Unit MIB – for the NMS, right-click on the antennas in the NMS for either side
of the link and select the “Diagnostic/Error Monitor” option. Record the results by
saving the data to a file. For SNMP access, use a MIB Browser and check the
mdrmteRFLinkPerf and mdrmteG826 Performance groups.
Record all results on a test record. See Section 5.7, SC5800 Test Record , page 37
for an example.