Wave Fitness WR-P, Руководство пользователя

Страница: 6 / 17

.
Tank filling and water treatment procedures .
Note: 17 liters of water is required for maximum
filling.
1 Remove tank cover plug and rubber fill plug
from the top of the tank.
2
Place a large bucket of water next to the
Pacific rower and position siphon with the rigid hose
in the bucket and the flexible hose into the tank as
shown. Note: Make sure small breather valve on
the top of the siphon is closed before filling.
3
Begin filling tank by squeezing siphon. Use
Level Gauge decal on side of tank to measure
volume of water in tank. Note: The amount of
resistance is dictated by the amount of water in the
tank; for example, 9 liters of water equals light
resistance, 17 liters of water constitutes heaviest
resistance. Important: Do not overfill tank!
4
After filling tank to the desired water level,
open the valve on the top of the siphon to allow
excess water to escape.
5
Ensure that tank plug and frame plug are
replaced once filling and water treatment
procedures are complete.
Tips on Siphon use : Putting the fill bucket higher
than the tank will allow the siphon to "self-pump"
when adding water to the tank.
Water Treatment Procedures:
1 Add Chlorine tablet.
2 Add very small amount of blue dye
and check for desired hue. Important! Do
not add blue dye for at least 72 hours
following Chlorine treatment. The blue dye
adds visual appeal as well as cutting down
the amount of light reaching the tank water,
thus extending the amount of time between
water treatments.