Wave Fitness WR-P, Руководство пользователя

Страница: 5 / 17

1
Water treatment pack (4 tablets).
2 Siphon.
3 Rear seat rail leg.
4 Rear seat rail leg mounting bracket.
5 Rubber bumpstop for seat rail (rear).
6 Seat rail rubber end cap.
7 M8X15mm rear leg bolts (2).
8 M6X10mm countersunk bolts (2). Note: Refer to this list on the assembly page, as shown (*).
Remove frame plug and tank plug. Siphon filling of tank.
Assembly Instructions
1 Install seat (3) on seat rail (2) with indentation facing rearward.
2 Position rubber bump stop (22) with bevel edge facing seat.
3 Mount and secure with bolts (25).
4 Position mounting bracket (21) inside seat rail (2).
5 Hold rear seat rail leg (20) in position beneath seat rail (2).
6 Secure rear seat rail leg to mounting bracket using bolts (24).
7 Insert rubber end cap (23).
8 Insert seat rail (2) inside main frame (1) as shown.
9 Insert horizontal frame bolt (4) through main frame
(1) and seat rail (2). Secure using 2x (5)(6) and dome nut (7). Do not tighten.
10. Using vertical seat rail bolt (11) through plastic cap (10), insert through seat
rail (2) and bottom of main frame. Secure using washer (8), and nylock nut
(9) See notes below.
11. Tighten horizontal frame bolt.
NOTE: Tighten vertical rail bolt (step10) until rower middle leg is slightly clear of
the floor. Adjust vertical bolt tension as required to prevent front end of machine
lifting when rowed vigorously.
Adding and treating water.