2 of 8
© 2020 tekmar 087_D - 02/20
To avoid serious personal injury and damage to the equipment:
It is your responsibility to ensure that this control is safely installed
according to all applicable codes and standards. tekmar is not responsible
for damages resulting from improper installation and/or maintenance.
• Read Manual and all product labels BEFORE using the equipment.
Do not use unless you know the safe and proper operation of this
equipment.
• Keep this Manual available for easy access by all users.
• Replacement Manuals are available at tekmarControls.com
• Disconnect all power before opening the control.
• Do not attempt to service the control. There are no user serviceable
parts inside the control. Attempting to do so voids warranty.
FCC ID:
2AHQR-10850A
IC ID:
21247-10850A
FCC:
This product has been tested and found to comply with FCC part 15 subpart C. Operation is subject to the following two
conditions: (1) this device may not cause Harmful interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation of the device. However, there is no guarantee that interference
will not occur in a particular installation. If this device does cause harmful interference to radio or television reception,
which can be determined by turning the equipment off and on. The user is encouraged to try to correct the interference
by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help
Warning:
Changes or modifications not expressly approved by the party responsible for compliance could void the user’s
authority to operate the equipment.
Industry Canada
This Device complies with Industry Canada License-exempt RSS standard(s). Operation is subject to the following two
conditions: 1) this device may not cause interference, and 2) this device must accept any interference, including interference
that may cause undesired operation of the device under Industry Canada regulations.
Le présent appareil est conforme aux CNR d'Industrie Canada applicables aux appareils radio exempts de licence. L'exploitation
est autorisée aux deux conditions suivantes: (1) l'appareil ne doit pas produire de brouillage, et (2) l'utilisateur de l'appareil
doit accepter tout brouillage radioélectrique subi, même si le brouillage est susceptible d'en compromettre le fonctionnement.
Warning: FCC and IC Radiation Exposure Statement
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. The antenna(s)
used for this equipment must be installed to provide a separation distance of at least 8 inches (20 cm) from all persons.
Cet équipement est conforme à l'exposition aux radiations de FCC et d'Industrie Canada établies pour un environnement
non contrôlé. L'antenne (s) utilisé pour cet équipement doit être installé pour fournir une distance d'au moins 20 cm à partir
de toutes les personnes.
This product is packaged with two AA lithium metal batteries and must be transported
in accordance with all relevant and international regulations. Contact your freight
company for more information. tekmar is not responsible for damages resulting from
improper transportation, installation and/or maintenance. For detailed instructions
refer to:
http://tekmarcontrols.com/support/lithium.html
This symbol identifies practices, actions, or failure to act which could
result in property damage or damage to the equipment.
