11 of 20
Installation
Each ProMelt panel comes pre-wired with a dedicated
tekmar snow melt control. The smaller, non-mixing pan-
els come standard with a 670, while the larger heat ex-
changer panels come with a 680. Both systems include a
Snow/Ice Sensor 090 or Snow Sensor 095.
Follow the wiring instructions in the tekmar Snow Melting
Control manual to connect to the heat source.
9. Plug in the tekmar control. A home screen will appear
on the tekmar control. Follow all instructions in the
corresponding tekmar literature to properly set up the
ProMelt panel.
3. Functional Performance:
Verify system initiates on a call for melting, interacts
with the WiFi and weather data properly, and cycles
on/off as designed.
4. Key Functions:
Identify key functions, features and training the
end-user on how to read, understand, and modify the
tekmar control. Outline how to move the system from
active to standby and how to engage a manual over-
ride if necessary.
It is important to perform a system start up approximate-
ly a month before the winter season. This process will
help ensure circulators and other components continue
to function as intended.
This section covers general commissioning steps and
procedures. Refer to the specific tekmar control manual
included with the ProMelt panel for complete details on
system set up and operation parameters.
Follow all boiler manufacturer recommendations for set
up, wiring, and operation.
1. Field Verification: Verify all installed system compo-
nents reflect plans and specifications. If there are
substitutions, verify compliance. If there are omis-
sions, check to see if the system design was revised
or if the omission is accepted by the project manager.
2. Operational Performance: Verify all components,
including boiler, function as designed. Ensure all
circulators run and water moves through the system
without hindrance. If a mix valve is present, ensure
actuators function and the valve opens and closes
normally.
System Filling, Commissioning and Maintenance
All panels are pre-wired with a stan-
dard 120 volt power plug. A transform-
er (if necessary) is provided on each
panel for the use of low voltage electri-
cal components. Do not connect high
voltage to low voltage connections.
WARNING
!
