![background image](http://html1.mh-extra.com/html/watts/blucher-connected-roof/blucher-connected-roof_user-manual-and-installation-manual_3779458012.webp)
12
BLÜCHER
®
CONNECTED ROOF - REV. 01 - OCTOBER 2020
6
Commissioning
Prior to commissioning, ensure that all Monitors have been installed and the Gateway is
mounted and wired according to the previous chapter.
1. Ensure power is OFF*
2. Remove SD card from the Gateway and open the Config file in an editor
3. Edit the Config file parameters to reflect the application (see appendix 13)
4. Save the Config file and place the SD card in the Gateway
5. Turn power ON*
6. Wait for all the Monitors to connect. This process can take up to 30 minutes. Alternatively,
enable Monitor Test mode to reduce time (see capture 7.6)
7. Verify that there are no errors or warnings in the display
8. Verify Modbus values and functionality**
* As an alternative to power OFF/ON the “Remove SD card” mode can be entered by pressing the Info button
for 5 seconds. When the SD card is mounted again, the Gateway will reboot and read the new configuration.
** This step is only for setting up BMS systems.
6.1
SD card
The SD card is used for configuring the Gateway and for storing log data. Out of the box,
the SD card will only contain the configuration file. This file is used to setup the system with
communication between a Gateway and Monitors.
NB:
Before removing the SD card, either power off or press the Info button for 5 seconds to
enter “Remove SD card” mode.