![background image](http://html1.mh-extra.com/html/watts/blucher-connected-roof/blucher-connected-roof_user-manual-and-installation-manual_3779458019.webp)
REV. 01 - OCTOBER 2020 - BLÜCHER
®
CONNECTED ROOF
19
Roof alarm settings
To compensate for different roof designs and conditions the behavior of the default algorithm
can be customized. This is to avoid unwanted alarms that relate to e.g. roof design flaws.
You can offset the values at each monitor in the configuration file. This is done in “ROOF
ALARM SETTINGS”. You can offset each m/- 5 levels.
Roof alarms setting
SAMPLE_NUMBER
Numbers of samples
SAMPLE_PERIOD
Time in minutes between samples
BLOCKED_SENSOR_LIMIT_FACTOR
BLOCKED_DRAIN_LIMIT_FACTOR
Sensitivity of the algorithm:
Higher value = Lower sensitivity
Lower value = Higher sensitivity
BLOCKED_SENSOR_ALARM_SET_COUNTER
BLOCKED_DRAIN_ALARM_SET_COUNTER
Counter of incidents that activate an alarm
BLOCKED_SENSOR_NOALARM_RESET_COUNTER
BLOCKED_DRAIN_NOALARM_RESET_COUNTER
Number of no incidents to set counter to 0.
AUTOMATIC_ALARM_REMOVING
Alarm removes automatic after time
WATER_LEVEL_OFFSET_ID_1=0
WATER_LEVEL_OFFSET_ID_2=0
WATER_LEVEL_OFFSET_ID_3=0
WATER_LEVEL_OFFSET_ID_4=0
WATER_LEVEL_OFFSET_ID_5=0
WATER_LEVEL_OFFSET_ID_6=0
WATER_LEVEL_OFFSET_ID_7=0
WATER_LEVEL_OFFSET_ID_8=0
WATER_LEVEL_OFFSET_ID_9=0
WATER_LEVEL_OFFSET_ID_10=0
WATER_LEVEL_OFFSET_ID_11=0
WATER_LEVEL_OFFSET_ID_12=0
WATER_LEVEL_OFFSET_ID_13=0
WATER_LEVEL_OFFSET_ID_14=0
WATER_LEVEL_OFFSET_ID_15=0
WATER_LEVEL_OFFSET_ID_16=0
Offset: +/- 5 levels, see figure below.
If a monitor is installed lower than the drain
Offset water levels -X levels
If a monitor is installed higher than the drain
Offset water X levels