![background image](http://html1.mh-extra.com/html/watts/bar-switchcontrol-sc-m2/bar-switchcontrol-sc-m2_original-operating-manual_3753417019.webp)
19
Montagehinweise für Zubehör und Ersatzteile:
• Replace mounting plate into the housing,
remove cams from the actuating shaft.
•
Insert the actuating shaft into the
housing.
• Equip the spare cam with the actuating
device, and push onto the spare actu-
ating shaft. Take care to observe, that
the actuating devices with their sides
are next to one another.
•
Fit the bar-switchcontrol onto the ac-
tuator, make the setting and electrical
connection.
Spare part set 8: Micro-switch
•
Disconnect the bar-switchcontrol and
pull the cam from the actuating shaft.
Remove the black mounting plate and
disconnect the switch from the terminal
block.
• Exchange micro-switches and reconnect
according to the circuit diagram on the
inner side of the housing.
•
Replace mounting plate into the hou-
sing.
• Push the cam onto the actuating shaft,
whereby the exact positioning is to be
secured (see also Fig. C in the chapter
„Adjusting the switching cams“).
•
Fit the bar-switchcontrol onto the ac-
tuator, make the setting and electrical
connection.
Spare part:
Round initiator / Slot initiator
• Disconnect the bar-switchcontrol and re-
move from the actuator.
• Press together the snap lock on the ac-
tuating shaft and pull out the shaft.
• Remove mounting plate and exchange
initiator.
• Screw mounting plate back in positi-
on and place actuating shaft in the
housing.
•
Remount the bar-switchcontrol, reset
the actuating device, and remake the
electrical connection.