![background image](http://html.mh-extra.com/html/watts/bar-positrol/bar-positrol_mounting-and-operating-instructions_876746017.webp)
17
Operating Instructions
bar-positurn2 and bar-positrol
English
6. Establish power supply.
7. Press the red button for the automa
tic initialisation longer than 2 seconds.
Chaser light during the initialisati
on process
Both endpositions will be reached
two times automatically
8. Initialisation is completed
successfully when all LEDs
illuminate permanently
9. Start up by switching back the
Initialisation switch from
„Init“
to
„Run“
.
10. Commissioning is completed.
ATTENTION!
6
7
• Please note that all safety functions are immediately available when swit
ching the initialisation switch from „Init“ to „Run“. This can cause an im
mediate switching of the actuator!
• In case of every (even accidental) switching to „Init“, the whole initialisation
process must be carried out anew, because the previously learned values
will have been lost.
• After every change of the end position and reassembling the actuator, do not
forget to make a new initialisation.