![background image](http://html1.mh-extra.com/html/watts/acv-assure/acv-assure_manual_3773962011.webp)
11
ServiceGuide-ACV-Assure
2133
EDP# 1917123
© 2021 Watts
When identifying a location to mount the Cellular Gateway,
the device must be placed away from large metal objects and
structures that can block cellular signal. Additionally, the cellu-
lar antenna is located on the upper right inner side wall of the
enclosure. When mounting, ensure that this part of the device is
away from any walls, wires, pipes, or other obstructions,
especially anything metallic.
1. Before mounting, apply power to the Cellular Gateway to
ensure there is adequate cell coverage. On startup, the CELL
LED will blink at a rate of 1sec. This indicates it is searching
for a cell connection. Once connected it turns steady blue.
If connection is poor, it will blink with short OFF pulse every
second. If there is a poor or no connection, find a new
location.
Once cell coverage is established, disconnect
power from the Cellular Gateway before proceeding.
2. Mount the Cellular Gateway at the selected location, using the
mounting tabs and screws provided with the kit. Screws to
attach the unit to the wall are not included.
3. Using the four-conductor cable supplied with the kit, connect
the Control Box to the Cellular Gateway. Route wires from
the WIRELESS terminals of the Control Box through the
Cellular Gateway’s wiring gland and connect to the matching
terminals.
PWR to PWR
GND to GND
Input 1: Blue/Orange Wire
Input 2: White/Green Wire
Six feet of cable is supplied with the unit, but the Cellular
Gateway can be located up to 100 feet away from the
Control Box. If additional wire is used it must meet the
required rating for the Control Box (300V, 22 AWG).
4. To prevent water or dust from entering the Cellular Gateway,
Control Box & Relay Box, tighten all wiring glands.
5. Apply power to the Control Box and Cellular Gateway.
1.
Startup
– Upon startup, the POWER LED will light up a
steady green to indicate power is supplied. The Cellular
Gateway will automatically go into its startup sequence.
During the startup sequence, the CELL and IoT LED will blink
blue, indicating the Cellular Gateway is searching for a cellular
connection. This may take up to 10 minutes. Once the cellu-
lar and cloud connections are established, the CELL LED and
IoT LED will be steady blue.
2.
Cellular Connection
– After the startup sequence is
completed, the CELL LED will be a steady blue if there is a
good connection. It will blink with short OFF pulses if there is
a poor connection.
3.
IoT Connection
– If there is a cloud connection, the IoT LED
will be a steady blue. IoT LED will blink if cloud connection
is lost or not established. It will continue trying to connect
indefinitely.
4.
Test Button
– When cellular and Cloud connections have
been made, you can send a test message through the
Syncta app by pressing the TEST button.
5.
Reset Button
– You can reset the Cellular Gateway and
restart the startup sequence by pressing the RESET button.
This will cause all on-going operations to cease.
Installation and Set-Up
Installing the Cellular Gateway
Setting Up the Cellular Gateway
WARNING
!
Ensure all power supply to the Cellular Gateway is turned off before
making any connections to the Cellular Gateway. Failure to do so may
result in electrocution, personal injury, and/or death.
Cellular Gateway
Cellular
Connection to
Internet
Wired to Control Box
NOTICE
If there is no cloud connection, users will not receive notifi-
cations via Syncta.