Watts Premier WP-1 LCV, Инструкция по установке, эксплуатации и обслуживанию

Страница: 8 / 14

FILTER CHANGE
8
Figure D
Watts Premier recommends changing the filter element
every 6 months.
Use Watts Premier’s replacement cartridge only. Other
filters may look the same, but only filters by Watts are
manfactured to fit your WP-1 filter unit in order to ensure
proper reduction of water contaminants.
Carbon Block Filter
WP-1 LCV Part# 101014
(a) Turn off incoming water supply to the WP-1 at the adapt-
a-valve. Note: There will be water in the filter housing.
Lift the faucet handle to relieve the water pressure.
(b) Remove filter housing from lid by turning it to the left,
as shown in Figure D.
(c) Remove used filter cartridge and discard.
NOTE: Do not discard filter-housing o-ring.
(d) Clean inside of filter housing with warm soapy water and
rinse to remove soap
(e) Lubricate o-ring with water-soluble lubricant (i.e. K-Y Jelly
® or Silicone lubricant).
NOTE: Do not use Petroleum based lubricants such as
Vaseline ®.
(f) Seat o-ring in groove in filter housing and insert new filter
cartridges into filter housing.
(g) Screw filter housing onto lid as shown in Figure D.
(h) Turn on water supply to filter unit at the Adapt-a-Valve.
(i) Check system for leaks.
To Loosen To Tighten