Watts Premier WP-1 LCV, Инструкция по установке, эксплуатации и обслуживанию

Страница: 10 / 14

10
Performance Data Sheet
Watts Premier Inc.
8716 W Ludlow Drive Suite #1
Peoria, AZ 85381
WP-1 LCV
GENERAL USE CONDITIONS:
1: System to be used with municipal or well water sources treated and tested on regular basis to insure bacteriological safe
quality. DO NOT use with water that is microbiologically unsafe or of unknown quality without adequate disinfection
before or after the system. Systems certified for cyst reduction may be used on disinfected waters that may contain filterable
cysts.
2: Operating Temperature:
Maximum 100
o
F (40.5
o
C) Minimum 40
o
F (4.4
o
C)
3: Operating Water Pressure:
Maximum 100-psi (7.43 kg/cm
2
) Minimum 20-psi
4: Maximum flow Rate:
0.50 gpm (1.89 lpm)
5: Rated Capacity:
600 Gallons (2,200 liters)
RECOMMENDED REPLACEMENT PARTS AND CHANGE INTERVAL:
Note: Depending on incoming feed water conditions replacement time frame may vary.
Description Part Number Change time Frame Cost
Stage 1: Carbonblock 101014 6 Months or 600 gallons of water $28.95
This system has been tested according to NSF/ANSI Standard 53 for the reduction of the substances listed below. The concentration of the indicated
substances in water entering the system was reduced to a concentration less than or equal to the permissable limit for water leaving the system, as
specified in NSF/ANSI 53. Testing performed under standard laboratory conditions, actual performance may vary.
California Proposition 65 Warning
WARNING: this product contains chemicals known to the State of California to cause cancer and birth defects or other reproductive harm.
(Installer: California law requires that this warning be given to the consumer). For more information: www.wattsind.com/prop65.
Substance
Percent
Reduction
Influent Challenge
Concentration
(mg/L unless noted)
Maximum Permissible
Product Water
Concentration
ALACHLOR* >98% 0.04 +/- 0.10 0.002
ATRAZINE*
>97% 0.009 +/- 0.10 0.003
BENZENE* >99% 0.015 +/- 0.10 0.005
BROMODICHLOROMETHANE (TTHM)*
>99.8% 0.300 +/- 0.30 0.015
BROMOFORM (TTHM)*
>99.8% 0.300 +/- 0.30 0.015
CARBOFURAN (Furadan)* >99% 0.08 +/- 0.10 0.04
CARBON TETRACHLORIDE*
98% 0.015 +/- 0.10 0.005
CHLORDANE 0.04 +/- 0.10 0.002
CHLOROBENZENE (Monochlorobenzene)* >99% 2.0 +/- 0.10 0.1
CHLOROFORM (TTHM)*
>99.8% 0.300 +/- 0.30 0.015
CRYPTOSPORIDIUM (see Cyst)
99.99% minimum 50,000/mL 99.95%
CYST
99.99% minimum 50,000/mL 99.95%
2, 4-D* 98% 0.210 +/- 0.10 0.07
DBCP (see Dibromochloropropane)* >99% 0.052 0.00002
1,2-DCA (see 1,2-DICHLOROETHANE)*
95% 0.088 0.0048
1,1-DCE (see 1,1-DICHLOROETHYLENE)*
>99% 0.083 0.001
DIBROMOCHLOROMETHANE
(TTHM;Chlorodibromomethane)*
>99.8% 0.300 +/- 0.30 0.015
DIBROMOCHLOROPROPANE (DBCP)* >99% 0.004 +/- 0.10 0.0002
o-DICHLOROBENZENE (1,2 Dichlorobenzene)* >99% 1.8 +/- 0.10 0.6
p-DICHLOROBENZENE (para-Dichlorobenzene)* >98% 0.225 +/- 0.10 0.075
1,2-DICHLOROETHANE (1,2-DCA)*
95% 0.015 +/- 0.10 0.005
1,1-DICHLOROETHYLENE (1,1-DCE)*
>99% 0.021 +/- 0.10 .007
CIS-1,2-DICHLOROETHYLENE*
>99% 1.4 +/- 0.10 0.07
TRANS-1,2- DICHLOROETHYLENE*
>99% 2.0 +/- 0.10 0.1
1,2-DICHLOROPROPANE (Propylene Dichloride)* >99% 0.015 +/- 0.10 0.005
CIS-1,3- DICHLOROPROPYLENE* >99% 0.079 0.001
DINOSEB* 99% 0.021 +/- 0.10 0.007
EDB (see ETHYLENE DIBROMIDE)*
>99% 0.044 0.00002
ENDRIN* 99% 0.006 +/- 0.10 0.002