Watts Premier RO-PURE Plus, Инструкция по установке, эксплуатации и обслуживанию

Страница: 7 / 22

Page 7
Connect tubes to the RO faucet (Figure A)
This RO faucet is equipped with quick connect fittings for easy tube
installation.
1. In the parts bag, locate one 1/4” red tube, one 1/4” blue tube and one
3/8” black tube.
2. Connect the STRAIGHT END of the 1/4”-BLUE
tube to the corresponding
fitting at the base of the faucet. Make sure the tube is inserted the full
3/4” into the fitting.
3. Connect the STRAIGHT END of the 1/4”-RED
tube to the corresponding
fitting at the base of the faucet. Make sure the tube is inserted the full
3/4” into the fitting.
4. Connect the 3/8” BLACK tube to the fitting at the base of the faucet with the
black ring.
Make sure the tube is inserted the full 3/4” into the fitting.
Mount the RO faucet (Figure B)
NOTE: A 1.25” mounting hole is required for faucet installation.
5. Make sure the Locking Tabs are “tucked”. Feed the tubes and the lower
faucet assembly through the mounting hole in the sink. Test fit faucet
placement.
6. Make sure the lower faucet assembly is seated properly inside of the rubber
washer groove
NOTE: Arrow on base indicates FRONT of faucet.
6. Using a Phillips screwdriver, tighten the two screws until snug. Then, tighten
each screw alternately until faucet is secure. Do not overtighten!
7. Inspect O-rings on lower faucet assembly. Lubricate with water-soluble
lubricant if needed.
Assemble Faucet (Figure C)
7. Align the release button on the back of the upper faucet assembly
approximately 45° left off the back of the lower faucet assembly.
8. Press the upper faucet assembly firmly on-to the lower faucet assembly
and twist clockwise until locked into place. Remove battery cover on faucet
handle, pull battery tab and replace battery cover.
To Remove Upper Assembly:
Press in the release button and twist upper faucet assembly counter-
clockwise.
Do not remove upper faucet assembly until all water has been
drained from the system and system has been fully depressurized.
L.E.D. FAUCET MONITOR INDICATOR
This faucet is equipped with a filter change indicator. The indicator light will
flash BLUE while the water is being dispensed. After approximately six months
or 2000 gallons of filtered water used the light will change to RED, indicating
that filters should be changed. After filter change you must reset the monitor
(Follow the Faucet Indicator Battery Replacement procedure on page 8).
DANGER
This product contains a button cell battery. If swallowed,
it could cause severe injury or death in just 2 hours. Seek
medical attention immediately.
Premier Monitored (Top Mount Twist) Faucet Installation
INSERT
3/8”-BLACK TUBE
INSERT
1/4”-RED TUBE
INSERT
1/4”-BLUE TUBE
RUBBER
WASHER
FRONT
RELEASE
BUTTON
BATTERY
TAB
TWIST
UPPER
ASSEMBLY
45° ONTO
BASE
LOCKING
TABS
BACK
Figure A
Figure B
Figure C
LOWER
FAUCET
ASSEMBLY
UPPER
FAUCET
ASSEMBLY
LUBRICATE
O-RINGS
FRONT