120F
•
Plug thepower supply unitinto a mainspower outletand switch on.
•
Load thepumphead with tube.
The pump is now ready to operate according to the default settings.
120S
Plug the power supply unit into a mains power outlet and switch on. The pump performs a power-on test
to confirm proper functioning of the memory and hardware. If a fault is found, an error message is
displayed. See
Refer to "Error codes" onpage 36
Load thepumphead with tube.
The pump is now ready to operate according to the default settings
.
Operating parameters may be changed by means of key-presses. See
Refer to "Manual operation — 120S
.
To return thepump to itsdefaultsettings, pressand hold
DIRECTION
on power up.
120U
Note: If you plan to operate the pump by controls external to the pump, the 15-way
D-connector must be connected before power is supplied to the pump (see 2.5 Automatic
control wiring and 2.6 Remote/automatic control and operation). If any change is made later
to the 15-way D-connector, it must be reconnected before power is supplied to the pump.
Plug the power supply unit into a mains power outlet and switch on. The pump performs a power-on test
to confirm proper functioning of the memory and hardware. If a fault is found, an error message is
displayed. See
Refer to "Error codes" onpage 36
Load thepumphead with tube.
The pump is now ready to operate according to the default settings
.
Operating parameters may be changed by means of key-presses. See
Refer to "Manual operation — 120S
.
To return thepump to itsdefaultsettings, pressand hold
DIRECTION
on power up.
m-120-en-02
20
