Watersnake
22
FOOT PEDAL CONTROLLER
FOOT PEDAL CONTROL SYSTEM ( OPTIONAL )
Please note that your Geo-Spot motor has two short leads coming from the
base unit.
To fit the foot control unscrew the cap from one of the leads and attach
the lead from the foot control to the lead on the motor until it is fitted well.
Either of the two leads can be used (the alternate lead is available for fitting a
Navigation Sensor if so desired.)
The low profile foot pedal control is used to adjust direction and speed. A
variable speed dial control is located at the right side of the foot control box.
(1) Turn the motor to the left by depressing Button 1.
(2) Turn the motor to the right but depressing Button 2.
(3) Use your heel to apply power by depressing Button 3.
(4) Momentary/constant switch. Toggling this switch alternately allows the
user to apply power momentarily, whenever the power pedal (3) is held down
(adjacent red LED is lit), or constantly, without touching power pedal (adjacent
green LED is also illuminated).
(5) Variable speed control dial.
NOTE:
If the optional Foot Controller is installed to the motor, please
remember that if you want to swap from the FOB controlling the motor to the
foot controller you must activate the foot controller. This can be simply done by
rotating the Variable speed control dial
(5)
back to zero and then advancing it
forward to hand control of the motor over to the foot control from the FOB.
1
4
2
5
3
Watersnake Geo Spot GPS Manual v3 2021.indd 22
18/5/21 4:31 pm
