Waters Network Systems
User’s Manual
Page 32
PSX/MS1008-TX
aggregated at the same time. If LACP is set to static trunking group, the additional
ports are on standby and able to aggregate if a work port fails. If it is set to local static
trunking group, the number must be the same as group ports.
NOTE:
Before setting LACP support, you have to set the trunk group.
4.34
State Activity
Active:
The port automatically sends LACP protocol packets.
Passive:
The port does not automatically send LACP protocol packets, and
responds only when it receives LACP protocol packets from the opposite device.
4.35
LACP Status
This screen provides the status of the LACP configuration.
4.36 Reboot
Switch
Rebooting the switch provides two choices.
Default:
Reset switch to recover default configuration
.
Restart:
Reboot the switch with new configuration settings.
4.37 Xmodem
Upgrade
To perform the Xmodem upgrade, press the
X
key to start upgrading for Xmodem.
Disconnect the terminal and modify baud rate to 57600bps. Then, reconnect. Once
attached, follow these instructions:
1. Select
send file
under the
transfer
menu on the menu bar.
2. Select
the
browse
button to select the path.
3. Select
1K Xmodem
from
protocol
.
4. Select
Send
.
5. After successfully upgrading the new firmware, please modify baud rate to
9600bps.
5.0 Web-Based
Management
This section introduces the configuration and functions of the Web-based management
of 1008 switch. The 1008 switch provides an embedded HTML website residing in flash
memory. Management functions can be performed from anywhere on the network
through a standard Web Browser.
