Waters Network Systems
User’s Manual
Page 36
PSX/MS1008-TX
Enable Delay Bound
– This setting limits the low priority packets
queuing time in switch. The
Default Max Delay Time
is 255ms. If
the low priority packet that stays in switch exceeds the Max Delay
Time, it will be sent. The valid range is 1~255 ms.
QoS Policy: High Priority Levels
– There are 0~7 priority levels
that can be mapped to high or low queue. When sending packets,
different priority Levels in VLAN Tag can be selected.
NOTE:
Make sure Max
bridge transit delay bound control
is
enabled before enabling
Delay Bound
.
o
Protocol Enable Setting
Enable Spanning Tree Protocol
– The default is
Disabled
. The
recommendation is to enable STP.
Enable Internet Group Multicast Protocol
– This option allows
you to enable IGMP protocol
VLAN Operation Mode
– You can make the selection between
802.1Q (Port Based) without GVRP VLAN mode, 802.1Q (Port
Based) with GVRP VLAN mode or Port Based.
IGMP Query Mode
- Recognize different Query from client or server
to decide which Queryer will be the first priority. There are three
modes to choose from:
Auto Mode
: Choose the indicated Switch, which has the
smallest IP address to be the Queryer.
Enable Mode
: Enable one of Switches to be the Queryer.
Disable Mode
: Disable the other Switches from being the
Queryer.
Console port information
– The console connection is a standard interface used to
communicate with the switch via the serial port on the workstation. Section 4.1
describes the console connection.
Port controls
- The following settings can be changed:
o
State
- You can disable or enable this port control.
o
Auto Negotiation
- Auto negotiation can be enabled or disabled per port
