Waterous Eclipse ES, Руководство по установке

Страница: 9 / 37

F-1031, Section 3028 Page 9 of 37
Air Filter Installation onto Compressor
Air Filter
0
The air inlet on the air compressor can be turned in 90 increments because
the bolt pattern is symmetrical. This simplifies installation of the air filter. If you
turn the inlet, you will need longer tubing. Either acquire colored tubing locally
or contact Waterous for the correct lengths and colors.
To change the rotation of the air inlet, disconnect the tubing, unbolt the inlet,
rotate the inlet and install the new tubing.
Mount the air filter, considering the following factors:
•
Air intake area must be unobstructed.
•
Air intake tubing should be as short and straight as possible. If length exceeds
12 feet, consult the factory.
•
Maintenance clearance must be adequate for removing and replacing the fil-
ter.
•
The filter should be in an area that is unlikely to get wet.
The air inlet tubing (not included) from the filter to the air inlet is usually made
of thin-wall metal tubing (3 in. I.D.) and rubber elbows. Plumb it as though it
were an engine air inlet. Do not use flexible exhaust tubing or any material that
water or dirt can easily penetrate (see Page 7 for dimensions of filter and el-
bow).