Waterous Eclipse ES, Руководство по установке

Страница: 12 / 37

F-1031, Section 3028 Page 12 of 37
Freeze damage due to undrained cooler.
Also shows small diameter of water tubes.
Oil Inlet / Outlet Ports
Oil
Outlet
Oil
Inlet
Drain
Water Inlet / Outlet Ports and Drain
Water Water
Outlet
Inlet
Drain
Adjustable Mounting Brackets / Cooler Mounting
Supplied by Waterous
Cooler mounted on the side of a pump com-
partment with the cooler body sloping toward
the drain for better drainage.
Oil Cooler
The oil returning to the compressor is cooled by passing it through a water-
cooled heat exchanger, usually called the cooler.
•
The cooler must be installed horizontally with the drain at the lowest point and
with a slight slope toward the water drain end.
•
The drain hose should be 0.5" I.D. minimum to provide proper drainage.
•
The outlet of the drain hose must be lower than the cooler's drain outlet. The
drain hose should be a continuous downward run (no goosenecks) to allow
proper drainage.
•
The hydraulic oil filter is mounted on the oil cooler. Make sure there is enough
room for servicing the filter.
•
To mount the cooler on the side of a compartment, unbolt the brackets from
the ends and reattach them so the cooler can be installed with the drain at the
lowest point.
•
The oil inlet and outlet may be reversed to make installation easier.
•
The water inlet and outlet may be reversed to make installation easier.
•
Install the cooler to allow for proper drainage to prevent freeze damage.
CAUTION
Do not install a shutoff valve in the oil cooler water supply. This will result in
system overheat and failure and voids the manufacturer's warranty.
NOTICE