Dual Sensor
Water/Soap Dispenser
Installation Manual
System Setup
1.
Remove the Dial Cover.
The system is a digital system. Do NOT attempt to
tamper with the electronic components in risk of
damaging the components.
2.
Setting the Faucet Sensor Distance
a. Press and hold the faucet system reset/purge
button (22) for about 5-7 seconds to clear CPU setting
memory, LED on sensor will turn on and stay lit to enter
setting mode.
b. Release button, LED will turn off, place your hand at
desired sensing distance, LED is flashing and wait until it
stays lit to complete new setting.
c. If your hand leaves sensing position range, water delay
will cut off after 2 seconds. Please reset to shorten sensing
distance and ensure water cut off time adjusts to 1 second.
d. Remove your hand and test new setting.
e. Factory default sensing distance is 4 in.
3.
Soap Dispenser Sensor Setup
Distance setting:
a. Press and hold soap system reset/purge button (20)
for 2 seconds (LED on sensor is flashing).
b. Press the reset/purge button again to enter setup mode,
Place your hand at the desired sensing
distance, LED will flash when the new setting is complete.
c. Test the new setting.
Continuously dispensing soap setting:
a. Press and hold the soap system reset/purge button
(20) for 5 seconds (LED on sensor stays lit) to activate
continuously dispensing soap.
b. If want to stop dispensing soap, press and hold soap
system reset/purge button (20) again for 2 seconds.
Important note: The soap dispenser will dispense soap
automatically for one time every 12 hours to prevent clogging
.
Soap system DIP switch (21) is for soap dispensing time
setting, Setting chart to the right. Factory default setting:
1 seconds. After setting, install back the dial cover.
20.
21.
22.
15.
Adjust the time of
dispensing soap
Switch 1
Switch 2
0.5 seconds
Off
Off
1.2 seconds
On
Off
1.5 seconds
Off
On
2 seconds
On
On
