WaterLogic WL800 - MAX II, Руководство пользователя

Страница: 39 / 74

WL800 Manual Page 39 – Revision 12-11-2018
Pre-installation and sanitization procedures as prescribed in this manual must be performed before
installing the WL800 Water Treatment System.
Always install indoors and place the Waterlogic WL800 Water Treatment System on a firm, flat and
stable surface.
Attach the water supply line to the orange 1/4” feed water tube at the inlet bulkhead fitting on back of
the unit. Waterlogic requires the use of a water pressure regulator. Water feed pressure must be
between 40-60 psi. Turn on the water supply and check for leaks.
1. Connect the power cord to the back of the Waterlogic WL800 Water Treatment System and to a
120 Volt supply.
2. Allow unit to fill.
3. Dispense Cold Water
4. Dispense Hot Water
5. Move the Waterlogic WL800 Water Treatment System into its final operating position. Be sure that
a minimum of 2” clearance is maintained around both the sides and the back of the unit. This is
important to allow proper airflow and heat exchange of refrigeration system.
6. Level unit using the adjustable feet to level if necessary. Never install on incline.
7. Once the unit is at the target temperature(s), sample the water to ensure water meets expectations
and additional rinsing or adjustment is not required.
8. Check the unit for any leaks. External Leak Protection is always recommended.