WaterLogic WL800 - MAX II, Руководство пользователя

Страница: 33 / 74

WL800 Manual Page 33 – Revision 12-11-2018
PRE-INSTALLATION INSTRUCTIONS
DANGER! ELECTRICAL SHOCK HAZARD.
Only qualified personnel who have read and understand this entire manual should attempt to
install, or service this unit, failure to do so could result in death or serious injury. DO NOT plug
into an electrical supply until specifically instructed.
WARNING! ALWAYS SANITIZE BEFORE USE.
Sanitize before use to eliminate any potential microbiological contaminates.
Materials Needed:
• Personal Protective Equipment. Rubber or Nitrile Safety Gloves and Protective Eyewear
• Phillips Screwdriver
• Temperature Gage
• Water Pitcher or Container to collect water from the faucet
• 20 Liter (5 gallon) container or drain basin
•
Sanitizer - Household Bleach (5.25% Sodium Hypochlorite) or Citric Acid Based Cleaner
•
¼” Plastic Tubing, at least 4 feet in length, and assorted ¼” quick connect fittings
•
TDS Meter and Test Strips for measuring chlorine - Optional
1. Unpack the Waterlogic WL800 Water Treatment System and check exterior for damage.
WARNING! WL800 Water Treatment System IS HEAVY.
Use proper lifting aids and handling techniques to avoid injury. Use assistance as single person
lift could cause injury. Always drain before handling and transporting and handling to reduce the
weight of the unit.
2. Remove the Drip Tray. Remove screw located on the lower
front cover. Removing this screw will allow access to the
inside serviceable components
3. Press down on the Front Cover Lower Assembly and
remove in the direction shown