WaterLogic WL4 Firewall, Техническое руководство

Страница: 13 / 25

24
Waterlogic 4 Firewall Technical Manual - Issue A, October 2010
25
Note - If all the icons should flash and an audible alarm sounds, please switch the
machine off immediately and call you authorised service agent.
1. No flow of water: Ensure that there is a water supply to the WL4 Firewall from the
building and that the installation isolation valve is turned on. If the installation kit has
an anti-leak device included in it (as Waterlogic Installation kit) then make sure it has
not tripped.
2. No flow of water: Check that the water filters are not blocked and that they are
in date and are screwed home securely into the filter head. Waterlogic recommend
filters are changed at 6 months. Check that the internal leak detection tray has not
filled with water.
3. The hot water is not hot and cold water is not cold: Make sure the green heater
compressor switch is turned on.
4. There is hot water flow but cold water is not flowing: This may be due to the
cold water tank being frozen. If so disconnect power supply for one hour to allow
NO WATER SuPPLY
Check the water supply
is turned on, if fault
persists please call your
authorised service agent
A FAuLT HAS BEEN
DETECTED
Please call your
authorised service agent
A LEAK HAS BEEN
DETECTED
Please turn off the water
supply and call your
authorised service agent
THE DRIP TRAY IS FuLL
Please empty the drip tray
THE uV LAMP
HAS FAILED
Please call your
authorised service agent
FILTER NEEDS
REPLACING
Please call your
authorised service agent
Malfunction Icons
The UV lamp
is operating Extra hot
water has
been selected The cold tank
is chilling The hot tank
is heating up Sleep Mode
- press any
button to bring
machine out of
sleep mode
Advisory Icons