background image

 

WL350

 Manual 

                                                                   Page 48 – Revision 11‐21‐2018 

WL350 COUNTER TOP DRAINING INSTRUCTIONS 

 

Draining Notes 
 

Drain the 

WL350 Water Treatment System 

for transportation. 

 

WARNING!

  

STORE UNIT EMPTY.  ALWAYS SANITIZE BEFORE USE OR AFTER SYSTEM 

FAILURE. 

The unit must be completely drained and sealed before storing to avoid stagnation and reduce 
microbial growth).  

 

 

Prior to draining the Hot Tank, turn off the Red Heater and Compressor Power 
Switch (

O=OFF)

, and dispense 2 liters (½ gallon) of hot water from the machine.  As 

hot water is dispensed from the faucet of the 

WL350 Water Treatment System

colder water will be introduced into the Hot Tank.  Since the Red Heater and 
Compressor Power Switch is turned off, the Heater will not energize and heat the 
incoming tap water.  Following this precaution prevents exposing personnel and equipment 
(drains, catch basin, etc.) to scalding hot water. 

 

Disable Cold and Hot Tanks 

 

1.

 

Turn off the Red Heater and Compressor Power Switch (

O‐OFF

) to disable the 

Heater and Compressor. 

2.

 

Dispense 2 liters (½ gallon) of water through the Hot Tank to cool the water 
temperature in the Hot Tank and avoid burns.        
 

WARNING!  

HOT WATER.  

The

 WL350 Water Treatment System produces Hot Water up to 

87°C (187°F).

 Water above 52°C (125°F) can cause severe burns or scalding.  Hot water should 

be dispensed carefully into insulated container to avoid injury.

 

 

Turn off Water Supply and Bleed Water Pressure 
 

3.

 

Isolate the 

WL350

 

Water Treatment System

 from feed 

water by turning off the supply.  
 

4.

 

Dispense cold still water to relieve any pressure built up in 
the system. 

 

5.

 

Remove the water supply line from the inlet line bulkhead 
fitting at back of the 

WL350 Water Treatment System.

 

 
 

6.

 

Depress Cold Water Dispense Button until all Cold Water has drained from the 

WL350 Water 

Treatment System.

 

 

7.

 

Depress Hot Water Dispense Button until all Hot Water has drained from the 

WL350

 

Water 

Treatment Machine

Water Supply Line

Содержание WL350










Отзывы: