Installation and connection
05.06.2015
20 / 80
Copyright
2013 by: WATERKOTTE GmbH. Subject to changes.
6.2.4
Connection tube of the tank (at the top)
The upper tube connection can not be directed through the insulation with
an installed bleeder. Therefore, the upper part of the bleeder has to be
mounted finally.
Procedure:
Remove the yellow plug.
Install the tube connection at the hot water tank.
Then fit the top of the bleeder (Z13683) on the tee of the connection
tube (see pointing arrow)
Use the supplied gasket.
Figure 6: Connection tube (at the top) with bleeder
6.2.5
Connection tube of the tank (bottom
)
The lower connection tube has no bleeder. Remove the yellow plug and
mount the tube connection at the hot water tank. Use the supplied gaskets.
Figure 7: Lower connection tube
