14
ADDENDUM 2
INSTALLATION INSTRUCTIONS FOR LEAK STOP FLOW INTERRUPTOR
Waterite now includes a non-electric leak detection device, with all residential RO systems. This
LEAK STOP
is easy to install and will automatically shut off the incoming water being supplied to
the RO unit if any water comes in contact with it.
Simply mount on the floor of the cabinet directly under your RO unit is installed. If a leak occurs on
the RO system, the sensor is triggered and an internal valve closes, preventing water from running
to the RO system and causing water damage.
The
LEAK STOP
is supplied with a mounting bracket, two-sided tape to make installation easy.
INSTALLATION INSTRUCTIONS
(see Figure 1 below)
For new system installations, installing the
LEAK STOP
should be your
LAST
step.
1. Turn inlet water valve off.
2. Using the 2-sided tape provided, place the
LEAK STOP
in a convenient location under the
RO system, in a place most likely to get wet in the event of a system leak. Make sure the
area is COMPLETELY free of moisture. Remove the tape film and push down firmly so that
tape adheres to surface. (Fig. 1 & 2)
3. Remove the red locking rings from the ports on the
LEAK STOP
device. (Fig. 3)
4. If desired you can also fasten the bracket directly to the base of the cabinet by using the
screw holes provided on the base of the
LEAK STOP
. (Fig. 1)
5. From the shut off valve on the main feed line, attach the ¼” (10mm) tube to the inlet side (IN)
of the
LEAK STOP
device. (Fig 3)
6. From the outlet (OUT) side of the
LEAK STOP
, connect a ¼” (10mm) tube to the cold-water
inlet of the RO system. (Fig. 4)
7. Make sure all connections are tight and that the tube has been inserted all the way into the
LEAK STOP
fittings. Secure the tubing with the locking rings supplied with the
LEAK STOP
.
(Fig. 4)
8.
Turn inlet water valve on. Make sure there are no leaks around the fittings
.
Figure 1
Figure 2
Figure 3
Figure 4
Screw mount holes
locking clips inlet
outlet
WARNING!
The LEAK STOP should be wrapped with a dry towel or cloth before changing cartridges.
This will help avoid it coming into contact with water that may be accidentally spilled in the
process.
Should the
LEAK STOP
device come into contact with any water, the device will
