Page
12
of
12
Pump
Pump Installation
1.
Do not run the pump dry. It needs water to cool its windings. The pump will burnout if adequate cooling is not available.
2.
Install the pump, in a pond or fish tank or hydroponic system, such that there is always a water supply available to the
pump.
3.
The pump will CAVITATE if it sucks water and air, which will noticeably destroy the pumps inner components.
4.
Do not lift the suction pipe out of the water while the pump is running, it will cavitate and destroy your pump.
5.
If you install your pump externally (Not using it in the submersible role) make sure your pump is installed below the level
of the bottom of your pond. This will ensure that your pump will always be primed. Centrifugal Pumps are not self priming.
6.
When fitting the piping to your pump, make sure that the joins are well made, without the possibility of leaks.
7.
Always make sure the suction side of the pump has a connection which does not allow air, or and Air/ Water mixture
8.
It is always best to have a position in the pool, pond or fountain which allows a secure immoveable positioning of the
pump.
9.
The suction should not draw water from the absolute bottom of the Water feature, Pond, Fountain, Fish tank, hydroponic
system.
10.
A filter is recommended.
11.
Dirt and debris can wear out and damage your pump shortening its lifetime. Most pump manufacturers supply spare
impellers and shafts which can be replaced to maintain the pump in good working order.
12.
Clean the filter regularly. Be attentive to the flow of water in the system and if you notice that it is performing poorly,
Clean the Filter or remove any obstacle preventing water from being sucked into the pump.
13.
Install a sieve or leaf trap, or skimmer to your pumping circuit. Make sure that leaves and debris are regularly removed.
14.
A small sand filter can be used to remove small particulate matter form your pond water.
For further illustration, watch our basic setup video here:
If you have any further questions, please contact us on
