PRIMARY AIR SETTINGS
MAXIMUM - Pull control lever (item 43) all the way
towards the front.
LOW (MIN) - Push the control lever (item 43) all the
way towards the back.
When inspecting a masonry chimney, start at the
cleanout door, normally found in the basement, at
the base of the chimney, or on the outside. If your
chimney does not have a clean-out door it must be
inspected and cleaned by removing stove from
chimney.
IMPORTANT: NEVER LEAVE THE STOVE
UNATTENDED WHEN THE FIREDOOR IS IN THE
CRACKED OPEN POSITION.
UNDER NO CIRCUMSTANCES SHOULD A N Y
FLAMMABLE LIQUIDS, KEROSENE, GAS OIL
LINE, NAPHTHA, ENGINE OIL, LIGHTER FLUID
OR CHARCOAL - STARTERS BE USED TO
LIGHT OR “FRESHEN UP” THE FIRE. NEVER
USE MANUFACTURED LOGS. KEEP ALL SUCH
LIQUIDS WELL AWAY FROM STOVE WHILE IN
USE
DO NOT USE GRATE OR ELEVATE FIRE - BUILD
WOOD FIRE DIRECTLY ON HEARTH.
DO NOT BURN GARBAGE/RUBBISH IN THIS
UNIT.
FUNCTION DIAGRAM OF LEPRECHAUN 90
O.S.A. WOOD BURNING STOVE
MAINTENANCE
WARNING: DO NOT CLEAN STOVE WHEN HOT.
GLASS
1.
How to Clean:
The glass will clean itself when there is sufficient
heat generated by burning fuel. The Air Way system
provides pre-heated warm air which keeps the glass
clean.
WARNING: DO NOT OPERATE THE STOVE
WITH BROKEN GLASS.
2.
How to Replace:
(a)
Open the door (item 6) and remove the 4
1/4” (6.4mm) counter sunk screws from the
inside Fire Door (item 8) and lift it away.
(b)
Remove the broken glass and gasket, take
the replacement glass and fit gasket.
NOTE: If the gasket is damaged, use a new gasket
DOOR ASSEMBLY
(c)
Replace the glass and fit the Inside Fire Door
(item 8). Tighten the 4 fixing screws.
(d)
Close the door to make sure that it is sealing
properly against the Front Frame (item 16).
VITREOUS ENAMEL CLEANING
General cleaning must be carried out when the
stove is cool.
If this stove is finished in a high gloss vitreous
enamel, to keep the enamel in the best condition
observe the following tips:
1.
Wipe over daily with a soapy damp cloth,
followed by a polish with a clean dry duster.
2.
For stubborn deposits a soap impregnated
pad can be carefully used on the vitreous
enamel.
3.
DO NOT USE ABRASIVE PADS OR OVEN
CLEANSERS CONTAINING CITRIC ACID
ON ENAMELLED SURFACES. ENSURE
THAT THE CLEANSER MANUFACTUR
ERS INSTRUCTIONS ARE ADHERED TO.
11