Waterco OXISWIM, Инструкция по установке и эксплуатации

Страница: 22 / 45

OXISWIM MANUAL
P a g e 22 | 45
IV. Use the chart that suits the sanitiser that you are running (Hydrogen Peroxide or
Chlorine). The charts are only a guide for dosage rates - some alteration to the
setting may be required based on the physical test results.
6.6 PUMP PROGRAMMING PROCEDURE – OXISWIM
Please note: The Oxiswim system comes preset to operate on a pool with a water volume of
50,000 litres. If your swimming pool has a different water volume, please refer to the
recommended dosage rate charts in this quick reference guide for the appropriate
percentages of feed and timer operation times for your specific size pool.
Steps:
1 – Set Time
2 – Set Timer (Program)
Welcome Screen
The welcome screen will look similar to the above. The only buttons needed for
programming are the buttons in blue on the bottom panel (
). The up and down
arrows will let you scroll through the menu or individual digits. To enable programming
press the up and down arrows simultaneously to enter the menus. To navigate through the
setting in each menu use the tick button (
) to scroll right and the ESC button ( ) to
scroll left. When completing any changes in the menu always click the tick button ( ) to
get to the end of the changes to save the settings.