Waterco Aquamaster
I pg 21
SYSTEM STARTUP AND TESTING
Touch Screen
The Aquamaster system comes complete with one touch screen control. An additional screen
available separately may be connected providing additional operational convenience to the owner.
There is a small jumper link on the circuit board which must be removed.
a) When two touch screens are installed one will be configured as the “master” and controls all
functionality. When the system is first powered up both screens will display the configuration
screen.
b) Whichever screen is used to complete the initial configuration becomes the master unit.
c) The slave or second screen will reboot and upload all configuration data.
d) The controller configuration menu will only be available from the master screen.
e) All user menus will be accessible from the Slave display.
f) If the master module is disconnected from the system or fails, the controller will restart within
a few seconds of being switched on. If the Slave display does not receive a message from the
master the slave display will assume master control operation.
Factory Calibration of Temp Sensors
The Reset button will return Aquamaster to factory settings.
CONFIGURATION
Initial Start-up and programming
Step 1 – Filter Pump Setting
Select type of filtration pump
Single Speed
3 Speed Pump
> Default speed
-
Low
Medium
High
Freeze Protection > Off / On
Freeze protection is used to protect the pool hydraulics and plumbed equipment against freeze
damage. If freeze protection is enabled and the AIR temperature falls below 3oC, Aquamaster will
turn on the filter pump to circulate the water. If in “Pool and Spa” mode the valves will also alternate
between the pool and spa every 30 minutes.
Filtration Timer 1
>set desired start time
>set desired Stop time
>set
desired
days
>Press the “Active” or “Not Active button to allow this timer setting to operate or to deactivate the
particular timer setting.
>press “Save Timer” when Timer 1 programming completed
Filtration Timer 2
>set desired start time
>set desired Stop time
>set
desired
days
>Press the “Active” or “Not Active button to allow this timer setting to operate or to deactivate the
particular timer setting.
>press “Save Timer” when Timer 2 programming completed
Press “Enter” to proceed to Pool Spa Configuration
Step 2 – Pool Spa Configuration
Locate the “Press to Configure” icon and scroll to the desired pool configuration setting:
Pool Only
Spa Only
Pool and Spa
Press “Enter” to proceed to configure your selection.