Waterco Aquamaster
INTRODUCTION
Thank you for choosing Aquamaster Pool and Spa Automation which provides you with a full range
of automation features. While you focus on fun, Aquamaster allows you to automate pool, spa, and
ancillary backyard functions like:-
• Pump
• Cleaner
• Filter
• Pool / spa landscape lighting
• Heater
• Water features
What’s included in the Package?
• Aquamaster Control Enclosure
• 1 x LCD Control Panel
• 2 x pool and air temperature sensors 3 metre
• 1 x roof temperature sensor 25 metre
• 1 x Control Cable RJ12 x 3 metres
Essential Accessories
• 1 x Flocheck valve
Optional Accessories
• Additional LCD Control Panel sold separately
• FPI actuator sold separately
• Waterco ECO Pump sold separately
• Waterco ECO Pump motor control cable sold separately
I pg 03
HYDRAULICS
a. Hydraulics Layout
Pool/Spa configuration
These systems use a single filter pump and filter. Pool or spa operation is controlled by two 3-way
valves (suction and return). In Pool/Spa Configuration, select: Pool/Spa Setup
Pool and Spa
i.
The Aquamaster can be programmed to accommodate spa spillover, if desired.
ii. A conventional heater (gas or heat pump) and solar can be used to heat both the pool and the
spa.
iii. If a chlorinator cell is plumbed prior to the pool/spa return valve, then both the pool and the
spa may be chlorinated.
iv. The pool water temperature sensor should be installed prior to any heater or solar and will
display either the pool or the spa temperature, depending on the current operation of the pool.
v. Note:- The temperature will only be displayed when the filter pump is running.
vi. If any water feature or pressure side cleaner boost pumps are used, be sure to enable the
“interlock” feature to ensure that the pumps operate only when the filter pump is on and the
system is in the “pool only” operating mode. The interlock feature ensures the filtration pump
is operating prior to allowing another system component to operate.
vii. The plumbing diagram below is intended to be used as a general guideline and is not a
complete plumbing schematic for the pool.
viii. We recommend the air sensor be installed for user convenience and for the freeze protection
feature for the filter, valves or aux outputs.
