WaterClinic LOTUS-75SS, Руководство пользователя

Страница: 15 / 48

ENG 13
the membrane shell. Doing so may cause permanent damage to the
membrane shell or membrane components (the membrane
manufacturer does not assume responsibility for returned components
due to damages incurred during installation).
• Damage to the membrane shell and reverse osmosis membrane
components inflicted as a result of the abovementioned reasons is not
covered under the water purifier’s warranty.
• Installation of the pipes
- Before installing the pipes, make sure that the surface of the pipes is
smooth. Cut the pipe on the front-end perpendicular with the length
of the tube with scissors and then make the cut section round before
inserting inside (see diagram 11 for the correct way of cutting);
If the pipe is not round, but still elliptical and then is inserted inside,
it will damage the O-ring and cause water leakage.
-
While installing the water pipe, it will get stuck at the first bayonet
before the pipe is completely seized by the connectors. Push it hard
until the pipe reaches the end. If the pipe cannot be inserted into the
deepest end, it probably breaks away when transferring the pressure.
(see diagram 12)
- When removing the water pipe, push in the jack catch first and then
pull out the pipe (see diagram 13).
- After the water pipes have been connected, safety clips should be
installed on the quick fittings to avoid the fittings to break away.
(see diagram 14)
Installation Notes
• If the power cord wiring needs to be longer, extend the cord
according to the wiring requirements and use an φ 8mm pinched tube
to wrap around the connection. Later, wrap insulating electrical tape on
the outside surface. Do not place the cord on the floor. The cord
should be suspended in the air or should follow a path above ground.
•
During installation, make sure that there is no electrical wiring or water
pipes embedded inside the walls where you will do the drilling.
Large O-ring
Large O-ring
Small O-ring
Membrane shell
Waste water
Inlet water
Inlet water
RO outlet water
Membrane shell cover
Diagram 10
Right way to cut pipes Wrong way to cut pipes
Diagram 11
Diagram 14
Diagram 12
Diagram 13
Clip (Before installation) Clip (After installation)