WaterBoss Filter Owner’s Manual
6/13/2012
13
Installation Steps and Start-Up Procedures, Cont.
Step 7
Flush Lines
A.
Place the appliance in the Bypass position.
(See Figure 7.) The bypass valve can isolate the
appliance should the system malfunction or leak.
The bypass valve enables you to use untreated
water for watering plants, shrubs, or lawns. To
engage the bypass
1.
Locate the dial-shaped knob located on the
rear of the main control valve.
2.
Turn the knob counter-clockwise until it stops
and the arrow points to “Bypass.” The
appliance will be bypassed, and all water to
the home is raw, untreated water.
B.
Turn on the main water supply.
C.
Open the nearest cold water faucet to flush the
plumbing of any excess soldering flux, air, or any
other foreign material.
D.
Return the appliance to Service position. Turn the
knob clockwise until it stops and the arrow points
to “Service.” (See Figure 8.)
Note:
To prevent untreated water from entering
your home, avoid using water inside your home
when the appliance is in Bypass position.
Remember to return the appliance to Service
position when you have finished using untreated
water.
Step 8
Check for Leaks
A.
Close all faucets.
B.
Check all lines and connections for leaks. If leaks
are found:
Figure 7: Bypass Position
Figure 8: Service Position
1.
Turn off the main water supply.
2.
Open a cold water faucet to depressurize the lines.
3.
Close the faucet to eliminate any siphoning action.
4.
Repair all leaks.
5.
Place the appliance in the Service position to slowly fill the media tank. (See Figure 8.)
6.
Open a cold water faucet to purge air out of the media tank.
7.
Close the faucet and recheck for leaks.
C.
Replace valve cover. (Hook front first, then push down back to lock in place.)
Содержание 900CF
Страница 35: ...Notes...
