Water Specialist WS1.25HR, Инструкция по эксплуатации

Страница: 17 / 59

WS1HR & WS1.25HR Manual Page 17
Step 1S – Press NEXT and
▼
simultaneously for 3 seconds and release. If screen in Step 2S does not
appear in 5 seconds the lock on the valve is activated. To unlock press
▼
, NEXT,
▲
, and CLOCK in
sequence, then press NEXT and
▼
simultaneously for 3 seconds and release.
Step 2S – Choose SOFTENING using the
▼
or
▲
button. Press NEXT to go to Step 3S. Press REGEN
to exit OEM Softener System Setup.
Step 3S – Select the time for the fi rst cycle (which in this example is BACKWASH) using the
▼
or
▲
button. Press NEXT to go to Step 4S. Press REGEN to return to previous step.
Step 4S – Select the time for the second cycle (which in this example is dn BRINE) using the
▼
or
▲
button. Press NEXT to go to Step 5S. Press REGEN to return to previous step.
NOTE: The display will fl ash between cycle number and time, and brine direction (dn or UP).
Step 5S – Select the time for the third cycle (which in this example is RINSE) using the
▼
or
▲
button. Press NEXT to go to Step 6S. Press REGEN to return to previous step.
Step 6S – Select the LBS for the fourth cycle (which in this example is FILL) using the
▼
or
▲
button.
Press NEXT to go to Step 7S. Press REGEN to return to previous step.
Cycle Options Units Lower/Upper Limit
Backwash Minutes 1 to 120
Rinse (fast) Minutes 1 to 120
dn Brine (combination of brining and slow rinse) Minutes 1 to 180
UP Brine (combination of brining and slow rinse) Minutes 1 to 180
Fill LBS 0.01 to 200
Service Minutes 1 to 480
OEM Softener System Setup
In OEM Softener System Setup the OEM chooses the time for the cycles selected in OEM Cycle Sequence and specifi es other
operating parameters for the system. The upper and lower limits of the allowable values for the cycles are as follows:
Note: Fill is in pounds of salt.
STEP 1S
STEP 2S
STEP 3S
STEP 4S
STEP 5S
STEP 6S
➟
STEP 7S
Step 7S –Set Grains Capacity using the
▼
or
▲
button. The ion exchange capacity is in grains of
hardness as calcium carbonate for the system based on the pounds of salt that will be used. Calculate
the pounds of salt using the fi ll time previously selected. Grains capacity is affected by the fi ll time.
The grains capacity for the selected fi ll time should be confi rmed by OEM testing. The capacity and
hardness levels entered are used to automatically calculate reserve capacity when gallon capacity is set
to AUTO. Press NEXT to go to Step 8S. Press REGEN to return to previous step.
Since no time is associated with the END cycle, the END cycle will not appear in the OEM Softener System Setup sequence.