Quick Set up Guide WG13 Alarm & Keypad 29 03 2022 V1
the back of the bracket and press the bracket onto your chosen location. Once the bracket is
secure, fit the keypad onto the bracket.
If using screws, remove the bracket from the base station and screw the bracket to the wall
with the screws provided. Fit the base station on to the bracket.
2.
Door/Window Sensor
Fit the Double-Sided Adhesive pad firmly to the back of both parts of the sensor.
Carefully place the sensors where required and press firmly to ensure a secure bond
.
Note:
the maximum distance both parts can be from each other is 2.5 cm. If the gap on the
door/window to the frame is greater than 2.5cm in depth you can use a PIR motion alarm
instead in this location.
Arm the alarm and open the entry door/window to test the alarm is working correctly.
3.
PIR Motion Sensor
Mounting height - Motion sensor should be mounted between 2m to 2.2m above the floor.
Mount the bracket with the adhesive pad or screw fixings provided. Fit the PIR motion sensor
in the bracket and set the direction of the detection range of the motion sensor.
Detection Area
Top View Side View
Notes
.
1.
Do not install the PIR motion sensor outdoors or on glass.
2.
PIR motion sensors cannot detect motion through glass if someone is moving outside
a window but it can give false alerts from outside motion or reflections so do not direct
the PIR towards a window from inside.
3.
Do not install in places where the PIR motion sensor could get wet.
4.
Do not install the PIR motion sensor within 1 meter of a heat source such as an electric
heater, heat vent or fireplace or a source that may produce turbulent air.
5.
Do not install the PIR motion sensor behind large appliances or furniture that may
obstruct its motion sensors.
4.
Wireless Keypad
Before installation, test the wireless keypad communication range with your base station
first.
It is not advised to mount the keypad onto metal surfaces as the metal can block RF
signals between the keypad and the base station.
Remove the bracket from the back of the keypad. Fit the double-sided adhesive pad to the
back of the bracket and press the bracket firmly onto your chosen location. Once the bracket
is secure, fit the keypad onto the bracket.
