28
4.5. Walk Test Mode
-
Walk test mode should be used when testing the system or after a new detector has
been learnt into the system.
TO ENTER WALK TEST MODE
1.
Safety Lock must
be off
Ensure Safety Lock has been turned off within the last 5
minutes. See
Section 4.2.
2.
Press both buttons
for 3 seconds
Enter Programming mode by pressing
buttons 1 & 2
together for
3 seconds
. The siren will
beep 3 times
to
confirm you have entered programming mode.
3.
Press 1 time
Within 3 seconds, press
Button 2
to select
special
features
. You will hear
2 beeps
as confirmation.
4.
Press 1 time
Within 30 seconds, press
Button 2
to enter
Walk Test
mode
. You will hear
2 beeps
as confirmation.
5.
Walk Test mode
The system will enter
Walk Test mode.
During this time,
the siren will
beep
the number of times of the
zone
which
has been triggered. Detectors which have been set to 24
hour mode will still trigger the alarm. If the tamper switch
is pressed the siren will beep once.
6.
Press 1 time to exit
Press
Button 2
to exit
Walk Test mode
.
