Watchguard DV-1 guide, Руководство пользователя

Страница: 115 / 142

TROUBLESHOOTING DV-1 BACK DOOR MAINTENANCE OPTIONS
115
The DV-1 back door screen displays with the following options:
1. Network Configuration
– Follow the steps in
Network
Configuration on page 115.
2. Hard Drive Maintenance:
a. Check Hard Drive for Errors
– Follow the steps in
Check
Hard Drive for Errors on page 83
b. Remove Configuration
– Follow the steps in
Remove
Configuration (Names, Settings, etc.) on page 84
c. Follow the steps in Hard Drive Quick Format on page 109
d. Follow the steps Hard Drive Full Format on page 113
e. Locale - Follow the steps in Setting the Locale on page 116
3. Reset Recording State
– Follow the steps in
Reset Recording
State on page 85
4. Factory Diagnostics
5. Reset
– Restart the DV-1 so that any new changes take effect.
The
Network Configuration
option allows the officer to enter
the DV-
1’s
IP Address and Subnet Mask . In most cases, you need
not change these values; however, if physically connecting to the
DV-1 via an Ethernet connection, the DV-
1’s IP address must be
correctly set to successfully communicate through the Ethernet port.
Two possible reasons for needing to connect to the DV-1 through an
Ethernet cable are:

Uploading configuration settings directly from the Fleet Manager
Utility to the DV-1 (bypassing the need to burn a configuration
file to a CD)

Running DV-1 diagnostics and maintenance from the Fleet
Manager Utility
Documentation for all versions of the Fleet Manager Utility is on the
web at: http://watchguardvideo.com/support
The DV-1 device is shipped from the factory with one of the
following default assigned IP addresses:

192.168.0.123 –
Existing systems

192.168.100.123 –
New or refurbished systems
If the DV-1 is unable to connect at
192.168.0.123
, try
192.168.100.123
.
Press
Next
to move the cursor to the next number placeholder.
Press the
Up

&
Down

keys to change the selected number.
Use
Up 20

to increase the selected number 20 at a time.
Press OK
when done making changes, or
Cancel
to exit without
configuring the network.