4. Insert the beaker in the unit from below; the vacuum will be released automatically.
Hold the beaker until the vacuum builds.
5. The mixer switches on automatically (depending on the settings – see point 1) for the set
period of time.
At the end of this period, an alert signal sounds for 5 seconds, after
which the timer display (6) flashes until the main switch (2) is switched off.
6. Take hold of the beaker before you switch off the
master switch (1)
(vacuum).
After the vacuum in the beaker drops, the beaker will no longer be clamped to the unit.
6.2.2 Wamix-Injector IV
1. Set the mixing time on the
timer (1)
(up to 999 sec.) using the buttons (4 and 5).
A: Automatic mixing
= set switch (3) to “I”) – mixing time is stored until a new time is set.
B: For manual mixing
= set the switch (3) to “0”, and switch the mixer on once vacuum is
created (set switch (3) to “I”).
Please note: The timer (total time) starts counting down as soon as sufficient
vacuum is achieved (beaker securely attached to the device). As this therefore
corresponds to the mixing time, the mixer can be switched on and off any number of
times (e.g. for pre- and post-vacuum). The beginning and end of the mixing time can
be read on the timer display (6).
15
1
2
3
4
5
6
fig. 6
