Wasp Wasp WDI7500, Руководство по продукции

Страница: 88 / 310

Enter/Exit Programming Mode
78 Wasp WDI7500/WWS750
Aiming Pointer
Enables/disables the aiming pointer for all symbologies.
$CTAAP00(CR)
Aiming Pointer = Disable
$CTAAP01(CR)
Aiming Pointer = Enable
DEFAULT
Aiming Duration Timer
Specifies the frame of time the aiming pointer remains on after decoding a
label, when in trigger single mode.The range for this setting is from 1 to
255 seconds in 1-second increments. See page 255 in “References” for a
description of this feature.
DEFAULT
LSTM00
Aiming Off After Decoding
LSTM
Set Aiming Duration Timer
To configure, scan the ENTER/EXIT PROGRAMMING
MODE barcode above, then the barcode at left fol-
lowed by the digits from the Alphanumeric charac-
ters in
Appendix D, Keypad
representing your
desired character(s). End by scanning the ENTER/
EXIT barcode.
Make a mistake? Scan the CANCEL barcode to abort
and not save the entry string. You can then start
again at the beginning.
~
CANCEL