Wasp Wasp WDI7500, Руководство по продукции

Страница: 258 / 310

References
248 Wasp WDI7500/WWS750
Label ID: Set Individually Per Symbology
To configure a Label ID individually for a single symbology:
1. Go to page 58 and scan the ENTER/EXIT barcode.
2. Select Label ID position as either BEFORE (Enable as Prefix) or AFTER
(Enable as suffix) by scanning the appropriate barcode in the section
"Label ID Control" on page 58. Reference Figure 10 for Label ID posi-
tioning options if multiple identification features are enabled.
3. Scan a barcode to select the symbology for which you wish to configure
a custom Label ID from the section "Label ID Symbology Selection − 1D
Symbologies" on page 59.
4. Determine the desired character(s) (you may choose up to three) which
will represent the Label ID for the selected symbology.
5. Turn to the ASCII Chart on the inside back cover of this manual and find
the equivalent hex digits associated with your choice of Label ID. For
example, if you wish to select an equal sign (=) as a Label ID, the chart
indicates its associated hex characters as 3D. Turn to Keypad, starting
on page 287 and scan the barcodes representing the hex characters
determined. For the example given, the characters ‘3’ and ‘D’ would be
scanned. More examples of Label ID settings are provided in Table 37 .
If you make a mistake before the last character, scan the CANCEL bar-
code to abort and not save the entry string. You can then start again
at the beginning.
6. Scan the ENTER/EXIT barcode to exit Label ID entry.
7. Scan the ENTER/EXIT barcode once again to exit Programming Mode.
This completes the steps to configure a Label ID for a given symbology.
Figure 10. Label ID Position Options
OR
Prefix Suffix Label ID Label ID Bar Code Data Aim ID