INTRODUCTION
© WASP S.r.l.
76
Use of the printer
8.9. Resurrection system
The Resurrection system is a command for the automatic recovery of the print jobs interrupted by a sudden
switch-off during processing.
The system is designed in particular for:
•
Blackouts and sudden power failures during printing
•
Accidental removal of the power cord during printing
The Resurrection system banner(fig 8.9) appears anytime a print has been interrupted for any reason and we
access the PRINT>START PRINT menu.
When the command STOP&SAVE is used to interrupt a print the process can be resumed\using the Resurrection
System banner.
Make sure to reactivate the VACS before restarting your printer as the shutdown may have released the printing
plate.
In addition, it should be considered that in the time span between turning off the machine and launching the
“Resurrection” command, the printed piece is cooled and this in some cases may cause problems in recovering
the print.
8.10. Set Z max
The height (often called Z max) of the printer is the value that defines the distance between the nozzle and the
print bed when it is in its zero position (home).
The height is part of the calibration values of the machine and the right value is essential for good operation.
This value is automatically saved by the machine during autocalibration.
After the AUTOHOME command it is possible in the main board to see among the values shown the Z max saved
in the machine (indicated as Z).
The command for manually setting a Z Max value can be found inside ADVANCED>TOOLS> Set Z max.(fig 8.10 a)
•
With a scale value of 100, click on the -Z arrow making the nozzle descend to about 20 cm above the printing
surface.
•
Select the scale value at 10 mm
•
With scale value 10, click on the -Z arrow making the nozzle descend to about 2 cm above the printing surface.
•
Select the scale value at 1 mm
•
With scale value 1, click on the -Z arrow making the nozzle go down to about 2 mm above the printing surface.
•
Select the scale value at 0.1 mm
•
With a scale value of 0.1, click on the -Z arrow making the nozzle go down until a slight friction is felt by placing
a sheet of paper between it and the top.(fig 8.10 b)
•
Click on the SET Z MAX button to save the new value or CANCEL to cancel the operation
It is necessary when it is not possible to perform an Autocalibration and in one of the following cases:
•
Nozzle replacement
•
Extruder‘s replacement
NOTE:
If the height set is lower than this measure, the tool will work higher than necessary, in that way the material will
not attach properly to the floor.
If the height set is higher than required, the tool will work at a level below the printing bed, with consequent
damage to the printing plate.
Содержание 4070 FX
