Wasp 4070 FX, Руководство пользователя

Страница: 58 / 86

INTRODUCTION
© WASP S.r.l.
58
Ordinary and extraordinary maintanance
7.3.2. Manual leveling
ATTENTION:
The manual leveling procedure will erase the values saved during the last autocalibration procedure.
These values will be permanently deleted.
Manual leveling is a command that allows you to adjust the inclination of the aluminum bed in order to match the
printer’s reference. A bad leveling can be the cause of a non-homogenous sticking to the bed on the first layer.
The command is found in ADVANCED>TOOLS>MANUAL LEVELING
Based on the three-point principle, the machine moves the tool to the vertices of an equilateral triangle
proportional to the aluminum bed.(fig 7.3.2 a)
At each point, by rotating a screw, the distance between the tool and the bed is adjusted. (fig 7.3.2 b-c-d-e)
Use a piece of paper(80-90 gr) as thickness between the bed and the nozzle.
Once completed, verify that the height in the center of the bed is similar to the other points. (fig 7.3.2 f)
If it’s not, contact the Manufacturer for support.
After manual leveling is recommended to carry the autocalibration procedure(see paragraph 8.2 Autocalibration).
Fig. 7.3.2 - Manual Leveling
fig 7.3.2 b
fig 7.3.2 a