12
1. Drop the knob into the larger opening in the
supply manifold lid.
2. Tighten securely. Do not overtighten! Do not
use pliers or other tools to tighten the knobs!
1. Select the correct size rubber ring which will fit
snugly on the chemical tube you are using.
Ring A is used for tubes with Ø5/16''.
2. Use scissors or a razor to carefully cut out the
proper size rubber ring. Wrap the rubber ring
around each tube after threading each tube
through the strain relief. Run the tube through
the compression nut to the bottom of the soap
box compartment. Cut the end of the tube at
an angle. Hand tighten the strain relief on to
the compression nut.
Separate lid which gives possibilities to add
powder detergent in compartment 1.
Installation
22
24
1332
3641
23
3643
Fig.
22
Fig.
23
Cut to fit
on tube
2
1
Multi-rubber ring
Strain relief
A
B
Compression
nut
Rubber
rings
Supply manifold
Fig.
24
