MAINTENANCE
10
Check the current at the power outlet with another tool.
Make sure that the outlet is not turned off.
Check that the charger contacts have not been shorted
by debris or foreign material.
If the air temperature is above 104°F or below
45°F, move the charger and battery pack to a room
temperature location and allow to warm up slowly.
WARNING
If the battery is inserted into the charger when
warm or hot, the
CHARGING LED
indicator light
on the charger may switch on and illuminate
RED
.
If this occurs allow the battery to cool inside of
the charger for up to 30 minutes. Charging should
automatically start once battery has cooled
CHARGER MOUNTING
–
This charger can be installed hanging on a wall
using two #8 screws (not included).
–
Locate the placement for the charger to be wall
mounted.
–
If fastening to wood studs use 2 wood screws (not
included).
–
Drill two holes on center 5.5 in. apart ensuring that
they are vertically aligned.
–
If fastening to drywall use wall anchors (not
included) and screws to secure the charger to the
wall.
Note: If the battery and the charger won’t be used for a
long time, remove the battery from the charger and pull
out the AC power plug
MAINTENANCE
WARNING
In order to avoid personal injury and the risk of
fire and electric shock, remove the battery before
adjusting, inspecting, cleaning the battery.
Cleaning
Remove the battery pack.
–
Brush or blow dust arid debris out of the air vents
using compressed air or a vacuum. Keep the air
vents free of obstructions, sawdust, and wood
chips. Do not spray, wash, or immerse the air vents
in water.
–
Wipe off the housing and the plastic components
using a moist. soft cloth. Do not use strong solvents
or detergents on the plastic housing or plastic
components. Certain household cleaners may cause
damage, and may cause a shock hazard.
Battery Pack
–
Store the battery pack fully charged
–
Once the light on the charger turns solid green,
remove the battery from the charger and disconnect
the charger from the outlet.
–
Do not store the battery pack on the tool.
–
After charging, the battery pack may be stored in
the charger, as long as the charger is not plugged
in.
Charger Maintenance
Keep the charger clean and clear of debris. Do not allow
foreign material to get into the recessed cavity or onto
the contacts. Wipe the charger clean with a dry, soft
cloth. Do not use solvents or water, and do not place the
charger in wet conditions.
Unplug the charger when there is no battery pack in it.
Fully charge the batteries before placing them in
storage.
Store the charger at normal room temperature. Do not
store it in excessive heat. Do not use the charger in
direct sunlight. Recharge at room temperature between
45’ F and 104’ F (7’C and 40’ C). If the battery pack
is hot, allow it to cool down inside of the charger. The
battery will begin charging once it has returned to room
temperature.
ENVIRONMENTALLy SAfE
bATTERy DISPOSAL
WARNING
The following toxic and corrosive materials are in
the batteries used in this blower.
Battery pack: Lithium-lon, a toxic material.
