GENERAL SAfETy RULES
5
EN
DANGER
To avoid serious injury, risk of fire, explosion
and danger of electric shock or electrocution:
–
DO NOT
probe the charger with conductive
materials. The charging terminals hold 240V.
–
If the battery pack case is cracked or damaged,
DO NOT
insert into the charger or tool. Replace
the battery pack.
–
DO NOT
charge these battery packs with any
other type of charger other than OEM.
–
DO NOT
allow any liquid inside the charger.
–
DO NOT
try to use the charger for any other
purpose than what is presented in this manual
WARNING
If the battery fluid gets in your eyes, flush immediately
with clean water for at least 15 minutes. Get
immediate medical attention. Do not charge or leave
out the battery pack in damp or wet conditions
including rain or snow. Do not immerse the tool,
battery pack, or charger in water or other liquid
.
–
Do not allow the battery pack or charger to overheat.
If they are warm, allow them to cool down for 15
mins. Recharge only at room temperature, never to
hot or cold.
–
Do not cover the ventilation slots on the top of the
charger. Do not set the charger on a soft surface
always use a solid surface. Keep the ventilation slots
of the charger clear at all times.
–
Do not allow small metal items or material such as
steel wool, aluminum foil, or other foreign particles
into the charger cavity.
–
Unplug the charger before cleaning and when there is
no battery pack in the cavity.
–
Do not leave the battery charger or use the battery
pack in direct sun or in a warm environment for
extended periods of time. Keep at normal room
temperature.
–
NEVER
try to connect two chargers together.
–
The battery pack cells may develop a small leak under
extreme usage or temperature conditions. If the outer
seal is broken and the leakage gets on your skin:
1a. Use soap and water to wash immediately.
1b. Neutralize with lemon juice, vinegar, or other
mild acid. Seek medical advice.
WARNING (PROPOSITION 65)
Some dust created by power sanding, sawing,
grinding, drilling, and other construction
activities contains chemicals known to cause
cancer, birth defects or other reproductive
harm. Some examples of these chemicals are.
–
Lead from lead-based paints
–
Crystalline silica from bricks and cement and
other masonry products
–
Arsenic and chromium from chemically treated
lumber.
Your risk of exposure to these chemicals varies
depending on how often you do this type of work. To
reduce your exposure to these chemicals, work in a
well-ventilated area, and work with approved safety
equipment, such as dust masks that are specially
designed to filter out microscopic particles.
WARNING
READ AND UNDERSTAND ALL INSTRUCTIONS.
Failure to follow safety rules listed below may
result in electric shock, fire, and/or personal
injury:
–
Arsenic and chromium from chemically treated
lumber.
–
Do not place the charger where the power cord
might be stepped on, tripped on, or subjected
to damage.
–
A battery-operated tool with integral batteries
or a separate battery pack must be recharged
only with the specified charger for the battery.
A charger that may be suitable for one type
of battery may create a risk of fire when used
with another battery.
–
Use a battery-operated tool only with the
specifically designated battery pack. Use of any
other batteries may create a risk of fire.